What does Drymat deliver, at what price, in what quality, with what durability?

The Drymat control unit, featuring state-of-the-art RISC chip technology, an LCD display, overvoltage protection and high-quality SMD components* – all MADE IN GERMANY. Every single component was built to industrial standard level 3 (DIN standard). This means: the maximum possible quality level in industrial manufacturing in accordance with the DIN standard.

Only quality SMD components* with the highest thermal constancy, which possess the highest thermal stability and are used, for example, in aerospace or implant technology (medical implants), are installed. For this reason, Drymat® Systeme can offer its customers a warranty of 20 years for the Drymat® control units.

The aim of the test is to approximately simulate the ageing of the Drymat electronic device over a period of 30 years by means of a suitable test. The ageing test was carried out based on the standard DIN EN 61709: "Electronic components – Reliability – Reference conditions for failure rates and stress models for conversion", incorporating the Arrhenius equation.

Thanks to the highly developed self-diagnosis system, all information is displayed in the form of messages on the LCD display. State-of-the-art RISC chip technology is used here. Diagnosis and problem-solving are thus handled simply and conveniently.

In addition, a special safety system causes the device to switch off should excessive voltage occur on the supply line (for example in the event of a lightning strike). A built-in, automatic self-protection that never requires a fuse change! In doing so, we are in constant contact with our engineers – every innovation, however small, that gives us competitive advantages in the market is implemented at short notice. Exclusively highly motivated regional specialists carry out research and coordinate with one another, implementing technical innovations swiftly.

Your advantage is our disadvantage: sometimes we cannot keep up with reprinting and updating our printed materials. Once a control unit has finally been produced, that is by no means the end of it: every circuit board is X-rayed once more and examined by optical lasers – only through our high quality standards can we convince our customers throughout Europe of our system over the long term.